• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Injectors

coolone

coolone

New member
Ok, so I'm pulling my injectors off the rails to replace the o-rings while doing my LIM, SCSI, TB, etc job... And as I'm getting the o-ring off one if the injectors, the little plastic ring on the end of the injector snaps and breaks.
:(

So now, the question is, how important is the piece? Is it to just hold o-ring in place? Can it be ignored. Does anyone have a part#?

Thanks for all advice, It's appreciated.
 


Most injectors do not use those little clips anyway. They are pretty handy though... I hate my 105# injectors without them.
 
My apologies for asking another question...

When putting everything back together today, I dropped and cannot find one of the Injector Clips into the engine bay.

It's the wire type clip that locks the wiring connector to the injector, not the flat metal clip that holds the injector to the rail.

I've looked all over the net and they're not listed anywhere. So, am I SOL, is it a big problem? I just worry that the connector could dislodge from the injector and that would be bad...

I appreciate your help!
:)
 
I had a EVO come into the shop without those metal clips on it... I ended up swaping some clips on from a spare connector.

Stop by a junkyard and grab one.
 


txslow6 said:
ZZP stocks them, but you will have to contact them.
Click to expand...

Thanks a million, and good news.

I used two tiny Ty-wraps to hold it together as a safety thing for now. I just had another shipment from them go out yesterday, guess I should've thought to ask but didn't so thanks :)
 
You must log in or register to reply here.
Back
Top