Confusingboat
New member
Does anybody have the ignition switch wiring diagram for 04+? I've searched for hours and come up with few results.
Ignition Switch Wiring Diagram
- Thread starter Confusingboat
- Start date
BillBoost37
New member
I do..but not here.
Confusingboat
New member
I can haz? 
Explicit_Spade
Perma-Banned! JK LOL
I can probably get it. Do you need replacement instructions or just a diagram?
Confusingboat
New member
I need to know what all the wires do. For a project 
Explicit_Spade
Perma-Banned! JK LOL
Hopefully that helps.
Confusingboat
New member
Woot woot, thanks! Where do you get these things?
Explicit_Spade
Perma-Banned! JK LOL
Most of the things I share are from alldata diy. Best $19.99 I've spent in a while (that was for like 3 years too).
Confusingboat
New member
So I've almost completed the circuit for my little project, but I just need to double check on a few things before I actually order the pieces, build, test, etc.
C1-A: provides constant +12v
C1-B: requires +12v to crank the starter
C1-D: provides +12v when a key is detected in the ignition switch (is this also post-PK3 logic???)
C2-A: provides constant +12v
C2-B: requires +12v when you want the vehicle to be on, cut power to this if you want to shut the vehicle off
C2-C: requires +12v when you want the accessories to be on (stereo, HVAC, etc), cut power to this if you want to turn the accessories off
C2-E: chassis ground
The reason I'm asking this here is so that I don't have to go rip my car apart just to test voltage scenarios. If all else fails I guess I'll have to do it anyways, but I figured somebody on here would know these things.
C1-A: provides constant +12v
C1-B: requires +12v to crank the starter
C1-D: provides +12v when a key is detected in the ignition switch (is this also post-PK3 logic???)
C2-A: provides constant +12v
C2-B: requires +12v when you want the vehicle to be on, cut power to this if you want to shut the vehicle off
C2-C: requires +12v when you want the accessories to be on (stereo, HVAC, etc), cut power to this if you want to turn the accessories off
C2-E: chassis ground
The reason I'm asking this here is so that I don't have to go rip my car apart just to test voltage scenarios. If all else fails I guess I'll have to do it anyways, but I figured somebody on here would know these things.