• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

How to Mod a LIM

How about drilling and tapping the front PCV passage for IC plates where front PCV is blocked off? LIM improvement and so much nicer than having a hose barb sticking out of the oil fill cap.
020ad5afddbe67429101968197a1d053_zpsf9e42931.jpg


8a625f699edaedd813fd0b226b1eba54_zpsb3b18143.jpg
 






I want to thank you for this thread! I had to do my LIM gaskets and saw this. I was able to locate end plugs. One thing I might of done different is I would of ground down the plug so I wouldn't have to tap so far to get it flush. The aluminum is thin there and its a fine line of getting the tap in just right! I believe I went about 13 1/2 turns on the first one so the second one I turned the tap in 12 turns and then slowly creeped it until I got the plug flush.
 


REDCOMPG said:
Did u bother to even read the first post it answers everything for you
Click to expand...
Yes I did and this wasn't in the first post "The ported supercharger housing increases the mass of air flowing out of the supercharger outlet by enlarging the factory restricted outlet and reduces heat generation resulting in an increase in horsepower."

This is the answer I was, more or less, looking for. Thanks anyway! I did a little research and found this. With that being said, I will do a lot more research before asking any questions.
 
You must log in or register to reply here.
Back
Top