Toms04compg
New member
Rico whats this milly lube stuff for the head bolts?... What does it do and should i remove bolts and use it?
help!
- Thread starter Toms04compg
- Start date
Rico
New member
Molybdenum based engine assembly lubricant. You can get it at your local parts store.
Warning: Don't put it on anything but bolts that require specific torque. If you put it on bearings it'll trash them.
Yes, remove the bolts, lube and retorque to spec. Make sure to put a little on the underside of the bolt head where it comes in contact with the head.
Warning: Don't put it on anything but bolts that require specific torque. If you put it on bearings it'll trash them.
Yes, remove the bolts, lube and retorque to spec. Make sure to put a little on the underside of the bolt head where it comes in contact with the head.
BillBoost37
New member
Or a dab on the head where the bolt goes...lol
Toms04compg
New member
That sucks i wish there info on it before starting .... Smh ok hopefully the bolts are good still thanks.
BillBoost37
New member
They are fine Tom.. listen to old man Chuck. He even knows how to use plastigauge.
Rico
New member
Dude, I know the bolts are still good if you're being honest that they have only been torqued to 37 ft-lb.
If you torqued them all the way either don't remove them or go get new bolts and start over. It's that simple.
Toms04compg
New member
Thanks guys and yes i only torqued one head to 37 ft lbs.