Beelzeboul
New member
so got my halos today took about twenty minutes to go through all my connections and wire and splice them ready for installation
I know the corner stock bulb gets moved over towards the middle by the way the harness clipped in but do I want to buy clear bulbs for the harnesses now?
the splicing for the positive of the LEDS goes into the furthest light bulb connector the brown or blue wires
I assume I want to take the bulb out rather than have it connected and rolling around(is it needed to complete circuit?)
after splicing and extending wires
plugged in waiting on word for which wire to splice too
(you can see rather than splicing to the negative of the harness I grounded it out to the bolt with the yellow connector there)
I figure either the blue or brown ones are what I want to splice too there but not sure which is pos and if it will work without a bulb in the socket to complete circuit
this one is painted I think I was looking to splice into the wrong two wires circled in white and the ones I wanna hit and circled in green
I know the corner stock bulb gets moved over towards the middle by the way the harness clipped in but do I want to buy clear bulbs for the harnesses now?
the splicing for the positive of the LEDS goes into the furthest light bulb connector the brown or blue wires
I assume I want to take the bulb out rather than have it connected and rolling around(is it needed to complete circuit?)
after splicing and extending wires
plugged in waiting on word for which wire to splice too
(you can see rather than splicing to the negative of the harness I grounded it out to the bolt with the yellow connector there)
I figure either the blue or brown ones are what I want to splice too there but not sure which is pos and if it will work without a bulb in the socket to complete circuit
this one is painted I think I was looking to splice into the wrong two wires circled in white and the ones I wanna hit and circled in green
Last edited:
