• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Gtx has a turbo!! lol



so change of plans going f body intake, got one at the yard today and tested it to see how it fits. Also a buddy is dropping off the oil catch can and my intercooler piping should be here on the 15:)
 





so I had to make a hole in the throttle body and in the intake so it will bolt up, use the Dremel on the inside to make the spot where I wanted the whole to go and then a drill bit

ordered all the rest of the stuff I need for the build pretty much except for one or two small things


getting ready for a little bit of body work tomorrow:)
 
Booba5185 said:
You gonna fill the holes in the doors? F-body TB wouldn't work?
Click to expand...

Yes they are being filled in tomorrow, and no the year I had was a drive by wire, and the other year you have to do the same, I have a ported tb I'm going to be putting on it, I just used a spare tb fto make sure I didn't mess it up.
 


mikejohnlewis said:
How difficult is the fbody conversion what parts do you need? And what rims are going on this?
Click to expand...

it's not too hard you have to move the battery to the trunk take the fuse box and move it where the battery was, I had to tap the throttle body and the intake so the one bolt on the throttle body would line up, you need a 98 alternator and bracket but it's not to bad, and right now it's just going to keep the pre gens
 


So I'm almost done with my car, getting everything together for next weekend for its tune, i can't wait to drive this car again, I got my injector holes on the fbody intake filled today, I started to clean the welds up to make it looks somewhat nice:)

 
STEVEGTX said:
So I'm almost done with my car, getting everything together for next weekend for its tune, i can't wait to drive this car again, I got my injector holes on the fbody intake filled today, I started to clean the welds up to make it looks somewhat nice:)

Click to expand...

Should've drilled and tapped those injector ports for some nitrous. :D
 


Just an advice, may want to ditch the worm clamps and upgrade to v clamps for the intercooler pipes and couplers.
 
You must log in or register to reply here.
Back
Top