• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

GOT MY BOOST GAUGE i have some Q's

GTPJOE90

GTPJOE90

New member
Hi guys where did everybody with a boost gauge in the a pod run the vaccum line through in the firewall?? also does anybody have a good pic of what line to tap into in the enginebay? thanks alot :th_thumb-up:
 


the vacuum line that sees boost and vacuum...

how are you rebuilding a motor again? i dont see how its possible when you cant figure out a mechanical boost gauge.

if you are still lost, put a T fitting on the MAP sensor nipple and run the vacuum line across with your fuel lines and into the cabin through the firewall by the drivers feet.
 
NO NO NO bio ughhh im saying i have it all wired in and ready to go the vacum line is already connected to the back of the gauge im jsut wondering where exactly to go through the firewall at and what to T into
 
thanks 01gtp but are you talking about the gromet on the passenger side? i think gtpsleeper didnt give me enough hose haha
 
just go through the firewall down by the drivers feet. take off the panels under the dash and look where the wires go out. push it through there.

the grommet in the floor on the passenger side is way out of your way.
 


im going into the grommet where the ebrake cable goes through correct???? i dont see it "screwdriver" that i put through the grommet??? hummmmm?
 
i just made a new hole with a drill carefully and put in my own grommet....but if i had known there was a good grommet to use i would have....
 


There is a rubber plug to the left of the steering column where it goes through the firewall. I pulled that out and used a drill to put a small hole in it and then reinstalled the plug. The nylon tube will come out below the brake booster.
 


Did any of you with autometers have problems getting the tubing threw the ferrel that goes in side the fitting at the gauge>
 
Under booster thanks man :) ill try tomarrow night im going to sleep fyi im exhausted engine is in and bolted to trans :) saturday afternoon is start up wooooooohooo
 
You must log in or register to reply here.
Back
Top