GenV Supercharger Pulley removal

[97gtpjoe]

Im trying to install an mps by smoothflow on my GenV supercharger , th instructions say to remove bolt from pulley and then use the pulley puller(purchased) only problem im having is that there is no bolt where I could put my wrench into any help will be appreciated thanks.

 

[matt5112]

should be a plastic "christmas tree" esque fastener then.

 

[97gtpjoe]

should be a plastic "christmas tree" esque fastener then.

Ok so how do I remove the fastener?

 

[TheOtherNick]

screw driver, or the special body tool.

 

[97gtpjoe]

the pulley is the one on top not the bottom one .

 

[gloebird]

yes, and a quick tip: that plastic piece will unscrew counter-clockwise. i wasted so much time trying to rip it out like a caveman. just unscrew it. then follow the instructions with the puller kit and its generally a piece of cake. make sure you put that modular piece on correctly, you only get one shot at it.

 

[97gtpjoe]

yes, and a quick tip: that plastic piece will unscrew counter-clockwise. i wasted so much time trying to rip it out like a caveman. just unscrew it. then follow the instructions with the puller kit and its generally a piece of cake. make sure you put that modular piece on correctly, you only get one shot at it.

Thanks gloebird! ill use some penetrating spray to soak the plastic piece its super tight.

 

[Swiggles]

Brake the flat part of the plastic and then use some needle nose pliers to unscrew the plastic plug. Go get a new pack of those plastic retainers (the plug) at a parts store and put one in.