• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Exploded my cv axle

minichopper6hp

Banned - Busted For Scamming
Well i grenaded the pass. side cv axle yesterday, any thoughts? Axle was only about 15k old, just out of the blue, took off from a light, burnt some rubber... crunch and BANG lol

Inner tripod was the failure point. Im not running that much power, any others had this problem?
 


ive seen it happen on poorly rebuilt ones or if there was a hard turn envolved with hard accel
lowered cars tear them up a bit faster aswell

could have just got a bum axle
 
If it wasn't a failure of the actual CV axle, you have a weak motor mount. I torqued my motor mount so hard with a launch on some DR's it popped the boot off and separated the tripod from the cup. I since then bought the poly motor mount from ZZP and it's locked up tight now with a new lifetime warranty napa axle.
 
No it was just the axle, no motor mount movement. You can reach down and the inner tripod just clanks around so something just snapped in there, not taking it apart to see because i have it under lifetime warranty.
 
ive seen this happen before a couple times. it happens because of poor castings,or bearings where not properly greased before they where sealed causing them to lock up and snap the tripod
 
Yea i just looked at it, it freewheels easy as hell lol. The inner tripod stays stationary while the shaft going to the hub just spins. Piece of ****.
 


i definetely hold the record i got 4 blocks from the shop after having it replaced when it shifted it was all like boom wwwwwwwwwwhhhhhhhhhhhhaaaaaaammmmmmmmmmmmmmm lol
 
I have bad struts and was accelerating on a hard turn that had a bump in it.. After I slowed down it was clunking so bad I though the engine went out, but it was the cv boot flapping around and being torn up.
 
i also have this problem...i replace the passenger side cv shaft four times a year..was so confused by it that i even swallowed my pride and had a pontiac dealership look at the car and they were just as confused as i am
 


Back
Top