• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Exhaust Tips



Tips installed with 3 tack welds, will be going to the exhaust shop for a full weld. I need to know how the position looks, before the full weld is done. Lots of pics at different angles;
P8100083.jpg

P8100091.jpg

P8100086.jpg

P8100085.jpg

P8100089-1-1.jpg

P8100090.jpg
 


The cut out are 5 inches, although the left is a little bigger than that. The pic represent how much bigger the left side is compared to the right. On level ground each tip is approx 11 inches from the ground and can't go any higher without surgery to the frame. The last pic shows a ground level shot. Tomorrow I'll be visiting the welder, if it doesn't rain.
P8100039.jpg

P8100031.jpg

P8100037.jpg

P8100036.jpg

P8100043-1.jpg
 
Last edited:
Thanks, I wanted it to look different than the other SS's in my area. Especially since I saw another Laserblue SS, the only difference was it was an Indy edition and it had big exhaust tips. It was at 5 am and I saw him go by while I was getting gas. I caught up to him at a stop light, saw the flags on the side and asked him was it an Indy. He said yes, the light changed and he drove away. Until then, I've only seen black and silver SS's in my area. I hope to see him again at a time we can have a real conversation. I always try to make my vehicles look a little different than any other of the same make.
 


You must log in or register to reply here.
Back
Top