• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Exhaust manifold

tomtom123

tomtom123

New member
Does anyone happen to have a picture of their front exhaust manifold? I forgot which bolts/studs go where. Also a pic of the rear will be helpful as well. Thank you!

Sent from my SM-N900P using Tapatalk
 


This depends on which dipstick you have.

The two outer ends are studs with nuts. start there, then put the bolt that ends at the head just to the left of the middle tube. After that.. it's fair game and you'll be able to do it w/o any worries.
 
jajata3a.jpg


Sent from my SM-N900P using Tapatalk
 


The one w/o the stud goes to teh LEFT (your other left) of the middle tube. Good luck getting your oil dipstick in the way you have it.
 
Before you start it up!! Make sure to clean the coating off of those headers and wipe off all your finger prints! Otherwise it will leave a really nasty dingy look to it.
 
Their going to look dingy anyways. Hell you kept stock manifolds for this long so whats the problem w/ dirty headers.
 
Bill, got the dipstick in just fine lol. But I appreciate the good luck ;P
Yeah, before I start it I was going to wipe them down with some mineral spirits or something like that

Sent from my SM-N900P using Tapatalk
 


Yeah. The compressor is caked in oil and grease from the previous engine spewing oil everywhere

Sent from my SM-N900P using Tapatalk
 
You must log in or register to reply here.
Back
Top