Engine Swap 2000 GTP

[Ibwrong]

Ok here it goes, helped a buddy of ours swap in a 98 Park Avenue motor.. Minus a couple of changes everything went as planned. Once we got everything hooked back up. The engine wont crank, we are using the old PCM but that shouldnt matter right? At the moment the fuel pump will intermitently kick in and the car wont turn over.. Im guessing a ground problem?

Any help would be greatly appreciated he just needs to get it back up and running....

 

[shawngtp]

check the gound wires that should goto the last hole in the bell on the left. There should be a stud to tighten the engine to the bell&trans then the grounds and then a nut that tightens the grounds to the stud.

 

[TorqueAutoMotiv]

theres also grounds on the starter aswell

 

[topswap]

If the park ave motor is the same as the gp, there is a ground under the coil pack too