• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

D.I.C flashing issue

J

jg2000gtp

New member
Alright so a few weeks ago my D.I.C started blinking 0 for everything while i was driving. a few minutes later it reset and went back to normal and since then it keeps doing it. it will be fine the go to 0 then be fine for a few minutes then do it again. i also noticed that when it goes to 0 the digital heating display flashes. does anyone know what this might be? i dont have a clue
 


It happened to me as well. I had a bad engine ground. Check your ground before jumping to buy a new PCM.
 


There's is a ground on one of the bolts connecting the motor & tranny, idk were the others are. Good way to check for this without having to look is to have the car tested for OHMs, if your car has too much resistance you more than likely have a bad ground.
 
thanks guys ill check the grounds tomorrow. Since my pcm may be junk and i was planning on getting a new one anyway is there any suggestions toward which one i should get. i was leaning toward overkill
 


i'd actually suggest overkill, just try to get in contact first before ordering to make sure you'd get it on a somewhat timely basis.
 
You must log in or register to reply here.
Back
Top