• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Custom Cold Air Induction [*]





Awsome Write up....I think I'm gonna make one, My buddy makes Lexan windows, so I can prolly get the lexan for very cheap
 
interesting. could you also install some insulation like what is inside the Wizair intake? if so, what would that insulation be called? This could be a fun project.
 
the lexan is alot more temp proof then the aluminum of the Wizardair, added insulation is most likely not needed
 


NEED INFO PLEASE!!

Have a 2001 GT, only Mod added is a Cold Air Intake, why at times, when you hit the gas hard (to the floor), car starts lagging and don't want to move unless yah let off the gas?????...........EXCELLENT SITE GENTLEMEN, KEEP UP THE GOOD WORK AND KEEP THE GRAND PRIX #1!!!!!!!!!
 
Where did you relocate the computer to? I was going to do a custom CAI in my '99 GT but abandoned the thought after realizing the computer is housed in the airbox....
 
RockNGTinVA said:
NEED INFO PLEASE!!

Have a 2001 GT, only Mod added is a Cold Air Intake, why at times, when you hit the gas hard (to the floor), car starts lagging and don't want to move unless yah let off the gas?????...........EXCELLENT SITE GENTLEMEN, KEEP UP THE GOOD WORK AND KEEP THE GRAND PRIX #1!!!!!!!!!
Click to expand...
Check the gaps on your plugs. More than likely one if not a couple of them are probably gapped way to big.
 
For the top and bottom pieces, are the angles the same for top and bottom against the fender?

Also, what is the angle on the bottom piece that is 3 5/8"?
 
any considerations for washing engine bay? i know that water is really bad for these, and i guess i am just wondering if the box is enough protection...
 


Great write up dude. I plan to use your dimensions to make this box fairly soon because i happen to have a cone and some lexan sitting in my basement...I was also interested in how you chose to affix the PCM though. I plan to incorporate tie wraps some how... haha

vailskier3 said:
any considerations for washing engine bay? i know that water is really bad for these, and i guess i am just wondering if the box is enough protection...
Click to expand...

what do you mean water is really bad for these? the K&N filters are washable! As long as you dont soak the filter while youre running the motor, theyre fine wet.
 
You must log in or register to reply here.
Back
Top