• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Could I use this LIM to put my Gen v on?

jayroca

jayroca

Banned
Ok guys took my intercooler off and my question is could I use this LIM
upahavuj.jpg



or do I need to use my GEN V LIM

Thanks!

Sent from my SAMSUNG-SGH-I747 using Tapatalk
 


So this wouldn't be a good LIM I just dont want to replace my LiM gaskets they are new they dont have no more than 20 miles on them but I dont want to buy new ones if I don't have to should I use a l32 gasket or just RTV the blower onto the LIM?

Sent from my SAMSUNG-SGH-I747 using Tapatalk
 
Ok thanks i'll reuse them again.. would u rtv or use a gasket?

Sent from my SAMSUNG-SGH-I747 using Tapatalk
 


Just make sure the opening is up to a gen v. Since the outlet is further up on it. That's if you had it set up with a gen 3 before. Use rtv on the corners only I have reused the metal gaskets many times before. You can also add a thin layer of rtv on the bottom and upper part of the gasket. I do it all the time. And if I ever remove it I just take it off with a razor
 
GTP89 said:
Just make sure the opening is up to a gen v. Since the outlet is further up on it. That's if you had it set up with a gen 3 before. Use rtv on the corners only I have reused the metal gaskets many times before. You can also add a thin layer of rtv on the bottom and upper part of the gasket. I do it all the time. And if I ever remove it I just take it off with a razor
Click to expand...

Thanks bro anybody got a pic on how they rtv'd the LIM? Thanks it would really help

Sent from my SAMSUNG-SGH-I747 using Tapatalk
 
Anybody? Any spots to watch? How did you guys rtv the o rings and pcv or should I just say f it and get the gasket?

Sent from my SAMSUNG-SGH-I747 using Tapatalk
 


Only thing I'd be concerned with is the pcv groove that is cut into the LIM.

If you are looking for a Gen V lim, I have a Gen 3 I modded to Gen V sizing with ported runners and plugged coolant ports. Happened to find it cleaning the garage last week.
 
l67ss said:
Gasket is like $12
Click to expand...

Where is this gasket located at? All the gaskets for the Gen v blower ive seen are 32$ and up do you mean the Gen 3

BillBoost37 said:
Only thing I'd be concerned with is the pcv groove that is cut into the LIM.

If you are looking for a Gen V lim, I have a Gen 3 I modded to Gen V sizing with ported runners and plugged coolant ports. Happened to find it cleaning the garage last week.
Click to expand...

Bill I have a Gen 3 LIM cut to fit the Gen v should this be good?
yhuda9un.jpg


you said the pcv groove the hole right below the lim correct?


Sent from my SAMSUNG-SGH-I747 using Tapatalk
 
If you look at the pic in the first post. On the lower left of the LIM is a groove, it's for the pcv with the IC. That is all I'd be worried about. Meanwhile..if you clean up that black LIM, we'dl let you use it.
 
Take off all the paint up top. You can use a gen 3 gasket and cut it up but I wouldn't suggested for you just get a gen v sc gasket
 


You must log in or register to reply here.
Back
Top