• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Clark's GTP "WHINER" LOWERED ON COILS 18X9.5'S



Re: Clark's GTP "WHINER" 37 pictures added 01\08\13

The engine bay is sexy because those stock ones with the cover off are plain ugly. The front end is bad ass bro.
 
Re: Clark's GTP "WHINER" 37 pictures added 01\08\13

97-03s like yours make me want to start my own build with those gens....
 
Re: Clark's GTP "WHINER" 37 pictures added 01\08\13

Fivefingerdeathpunch said:
Going from a 3.2 to a 2.8 is a huge difference, if it was me, I wouldnt drop that low. You're talking like alot of boost here and I bet the car would be faster with a 3.0 and more timing.
Click to expand...

I have that option aswell. It's so easy to swap back and fourth I'm going to pick the tune that I like the best. More timing or more boost haha timing is usually the option but ill 1/4 test both and go from there
 




Re: Clark's GTP "WHINER" 37 pictures added 01\08\13

TLSheff said:
I would hope so with the mod list.
Click to expand...

Ya I fear I might be going turbo later hahha just because I like going... Faster and faster. I've pretty much pushed the s/c setup to its limits. I could do meth and ramp up the boost a little bit I guess
 
Re: Clark's GTP "WHINER" 37 pictures added *pg21*

To get those clean sharp lines you desire with plasti-dip just spray one thick coat and immediately remove the tape so that it doesn't dry and bond to the tape.

Also how's your tans holding up?
 
Re: Clark's GTP "WHINER" 37 pictures added *pg21*

Jomamma said:
To get those clean sharp lines you desire with plasti-dip just spray one thick coat and immediately remove the tape so that it doesn't dry and bond to the tape.

Also how's your tans holding up?
Click to expand...


I was going to do that the next time plasti dipped it. And I have a stock Frankentranny it is not slipping yet. I've done multiple pulls an burnouts on the strip. It's kinda mind boggling actually. I do have a built one as a spare. When or if this one goes I have a suitable replacement. Just don't feel like doing the job until I have to
 


Re: Clark's GTP "WHINER" 37 pictures added *pg21*

^ you shoudn't even get an answer for that since you don't know how to read anyway.
 
You must log in or register to reply here.
Back
Top