• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Cam install with engine pulled. What Gaskets should I replace?

B

Blake71091

New member
Installing my cam soon...

What I have so far as far as gaskets go...

LIM gaskets
Cylinder head gaskets
Front engine timing cover gaskets
Valve cover gaskets
Gen V gasket
N* gasket
exhaust manifold gaskets
oil pan gasket
aluminum coolant elbows

dropping the tranny aswell so not sure about tranny pan gasket?

Fill in the blanks for me guys Thanks!
 


LIM: If you already have metal LIM's, flip the motor over and the lifters will clear the cam. No need to pull the LIM if you already have a good gasket.
HG: I wouldn't usually suggest these, our HG's are typically not a problem. If you decide to push forward, I'd recommend ARP head stud kit.
Oil Pan/Timing cover and rear engine gasket: hopefully you noticed the lower conversion gasket set is cheaper than all these combined.
Valve cover: ensure you have grommets.
Exhaust gaskets, I dislike new exhaust gaskets that are not MLS SS like the factory ones. Usually a cleaning works perfectly on the stockers. Cleaning the lead based aftermarket gasket off if you ever pull an engine is a pain.
Trans gasket, like Cam said, it's considered lifetime as long as it's in good shape. Might consider the axle seals though.
 
You must log in or register to reply here.
Back
Top