• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Cam gear bolt

G

guimond47

New member
Hey guys im ready to take off my cam gear and chain but the bolt on the gear do i turn it clock wise or counterclock wise to llossen it . That bolt is on so tight... And i dont know what way to turn it and cant fit an impact in my car.. How do i do this...
 


Your impact probably doesn't have enough torque. Its a bit of a hassle, but if you use a breaker bar, it should be a little easier.


"Remove the crank bolt using an impact if you have one. If not this is going to be a PITA for you to loosen. Then again the impact may not even take this off. You will need a breaker bar for sure. Have fun breaking it loose. Once it is off we now need that J-tool that will remove the pulley. If you don't have it or can't obtain one here is how you can make one in the next paragraph."
Eric Buono's Cam Install
 
Ok i got it losse thanks lol and umm i have a balance shaft question . I have a gtp botto
End and a gt bottom end and the balance shaft in the gtp bottom end is heavier than the gt balance shaft. Why is that?
 
You must log in or register to reply here.
Back
Top