• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

bumper cover crack

yzboy85

yzboy85

New member
So I noticed that one side of the fascia on my rear bumper was kind of hanging down. I looked underneath the car and the bracket hole that the clip goes through to hold it to the frame seems to be cracked. There's no parts of it missing, just a straight crack through to the center hole. I guess it was enough to get it free from the clip when going over a bump or something.

This may be a dumb question but I was wondering what the best way to repair that small crack would be so that it doesn't come loose anymore? Also was wondering how to get the clips out as well. I can't really see the back end of them so I don't know how they're held on.

The fascia being uneven is starting to really bug me =/
 


on my regal those large clips under the bumper were center push pin type, pull the middle out, then the fat outer part will pull out. its like a big molly.

i did have to hammer a small screw driver into the side and pry 2 of then out, the middle part that is.

they sell bumper repair kits with mesh, or use a plastic welder. or JB weld.
 
You must log in or register to reply here.
Back
Top