Boost by pass

[duane9586]

I ordered a pcm from overkill and this is what he said (I am putting in a S/C engine in place of my N/A on my 2005 gp) any input or advise.

This is what he said:
Only question mark on doing the swap is hooking up the boost bypass valve. I'll look through my wiring diagrams and try and find the PCM PIN for it, then I'll scan it so you know where it is. If it hooks up like the pre-gen (more than likely), you'll need to hook up the two wire connector to the PCM PIN and the other to a 12 volt source.



TIA

 

[Bio248]

just dont hook it up at all. mine is run with one vacuum line, thats it. you need to leave the lower nipple open to the atmosphere.

 

[duane9586]

just dont hook it up at all. mine is run with one vacuum line, thats it. you need to leave the lower nipple open to the atmosphere.

Thanks for the info i didn't know that.

 

[QwikGT]

mine is the same way as bio suggested....looks like you have no need for that hv3 huh?

 

[duane9586]

mine is the same way as bio suggested....looks like you have no need for that hv3 huh?

posted it for sale last night and sold last night but it looked nice sitting in my garage for a little while...