• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

blower motor help

Toms04compg

Toms04compg

New member
04 gtp changed out blower motor as it melted nothing... saw the 30 amp jfuse was blown so I replaced it and still nothing is there any other fuses for that? Blower is not working but still got heated seats and the re circulation button lights up when I turn the knob on though...
 




I was thinking on the new ones that everything runs threw the resistor I have a 2000 but I though all the new one ran from the control head to the resistor then the blower motor
 


04blower_zps8b6cca6f.jpg
 
sounds stupid but leave the resistor plug out. i installed my new blower once it went. after replacing the blower i didnt have any control over the HVAC. unplugged the plug that connects into the resistor and turned the car back on and everything worked..
 
ya. i unplugged the connector to the resistor (after i installed n hooked up the new blower motor) and it worked. Then plugged the connector for the resistor back in and still working fine. It was weird cause after i installed the new blower motor and had the resistor connector plugged in, i had no control of the HVAC. Then i ended up starting the car again with the resistor connector disconnected and i gained control over the HVAC again lol
 


Honestly Bill I'm the worst at reading or understanding those... I'm gonna see if there's a fuse or relay I missed besides the 30amp J fuse under hood.this is frustrating as I just can't see the blower motor and resistor going out at the same time.
 
I'm a little disappointed you didn't take my advice last night in chat...I mentioned THREE fuses. You replaced one already, so there are two left to check.
 
You must log in or register to reply here.
Back
Top