Blower motor cover install w/pics also fixed my DIC

[Boosted02GTP]

I got the part yesterday and decided it was warm enough to do it today. I followed the write up and it took about 15min..it was too easy. I wish it would of taken longer because I like doing things like this.

After a long and hard winter it got a little dirty but I'll get it looking like new soon enough.

I started undoing the clips and moved the solvent tube out of the way.

When I pulled off the cowel this is what I found...the seal was laying over the opening :th_shakinghead1:

After installing my new peice.

Done!!

These pictures were taken with my cell phone so I'm sorry about quailty and size.

Edit**

I just got back in from tearing my dash apart and replacing 3 blown bulbs in my DIC. It's much brighter now, I'm pleased with the results.

 

[Blown97]

Good pics, there is a how-to-section that covers this. I would recommend posting this in that thread as well, a couple more pics couldn't hurt for others who will need to do this.

 

[Bio248]

why did you install a new one? you could have just used silicon to make the old one stay where it should be.

 

[TDCRacing]

glad you got it fixed.

 

[blueguy]

why did you install a new one? you could have just used silicon to make the old one stay where it should be.

The one he installed creates a shield vs. the stocker which allows water to run down on top of the motor IIRC...

 

[Boosted02GTP]

This a tube of that stuff is like $8 and it might work...this is 100% failsafe. It's just a peace of mind for me I guess. This cost a few bucks more for me and I guess If you get it from the dealership it would be cheaper then that goop. I think it was worth it.:th_thumbsup-wink: