• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Blower Module Removal

tdm571

tdm571

New member
WTF! Could they have made it any hard to get that last f---ing screw out to replace the d--n thing. I mean, seriously, it's not like those things are rock solid. They seem to go bad quite often. So why not make it just a little bit easier to remove. Phew. I few much better now. Time to go piss myself off trying again to get that last screw out.
 


Finally able to get my socket on the d--n screw. Didn't even bother to tighten it back up. When the thing blows again, I'll remove the front screw and pull it out since the back two are slotted. What a big PIA!!!!!
 
all you do is remove the front screw, and pull it out with a pair of pliers, breaking the back tabs off. Then loosen the back bolts with a wrench and slide the new one in.
 


Yah, I had to remove my Blower Motor from the Dash. It was a PITA. I also had to replace the resistor. All thanks to that rubber drain over the HVAC intake coming loose. Good times.
 
Yeah, the blower motor module under the passenger side dash. I just managed to get my socket on it to loosen it enough to pull it forward. Major PITA.
 
You must log in or register to reply here.
Back
Top