• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Are gen III and gen v snouts interchangable?

T

tweeder

New member
I have the gen v sitting on the shelf but I need to mod the lim first but might leave that for the winter. My gen v has a smaller mps on it and I was wondering if I could take just the snout and swap it for now to run the smaller pulley.
 


Isn't the snout on the Gen 5 shorter too? Or is it the Gen 3 that's shorter? Either way one of the snouts is shorter than the other. Im sure it would bolt up though lol.
 


I put the gen v snout on top of the gen III and they look within 1/4" in length. I took a closer look and the bolt pattern is different.
 
Gen 5 supercharger will bolt and work with a gen 3 manifold.

The air inlet is bigger on the 5 but will still be good.
 
tweeder said:
I have the gen v sitting on the shelf but I need to mod the lim first but might leave that for the winter. My gen v has a smaller mps on it and I was wondering if I could take just the snout and swap it for now to run the smaller pulley.
Click to expand...

I referring to your original post were you have a gen 5. You don't have to mod the manifold.
 


Sure but how much more beneficial nobody knows.. I doubt it's anything really noticeable probably more of those mental mods.
 
REDCOMPG said:
Sure but how much more beneficial nobody knows.. I doubt it's anything really noticeable probably more of those mental mods.
Click to expand...

Well that's good to know that I don't have as much work to do. I might as well port the blower before it goes on, not much work compared to the hen III porting.
 


You must log in or register to reply here.
Back
Top