aem hook up

[gotboost3]

if i get a aem uego wideband and i got pacesetters catless would i hook up the o2 for the aem where the rear o2 goes? i have mine plugged right now im assuming yes but just making sure that i wouldnt have to make a new bung...would you guys recommend this aem with guage or getting an lc-1 and wiring it up to my aeroforce?

 

[Bio248]

if you have a cat, no not the same place. you have to put it before the cat. i put mine right after where my headers exit. built my own downpipe and catback though.

 

[gotboost3]

cant you just get a o2 pigtail and use one sensor?

 

[Sabrewings]

The PCM can't read a wideband sensor.

I think some you can rig up the controller to emulate a narrowband to wire up to the stock wiring. You'd need to look at the capabilities of the controller though.

 

[gotboost3]

so then if i have no cat i can put the aem's o2 in the spot for the rear o2 on my pacesetter dp? because the cat wont alter the readings.....

 

[Sabrewings]

That's correct.

 

[gotboost3]

thanks!

 

[Bio248]

the AEM setup will come with a wideband o2 sensor. you need to weld it in in it's own separate bung unless you delete the cat and run it in the rear o2 bung.

 

[gixer2000]

He did say in his first post he had catless pacesetters. use the rear o2 bung and you will be fine