93 mustang gt, killed

[thomas mcnulty]

Or the whole motor

 

[Fivefingerdeathpunch]

Nah, just the plugs.

Shouldnt be long, so I'm not worried.

 

[thomas mcnulty]

Nm, if I blow another engine take the car

 

[Fivefingerdeathpunch]

FYI, take the 3.4 off, in case you didnt get the hint yet.

 

[KeithGTP03]

Man, these mustang kill threads always get so much run.

 

[Slowpoke]

Man, these mustang kill threads always get so much run.

Because a mustang kill thread is like the boss's hot daughter to you GP guys. You know the thread is not going anywhere, but you still want to bump it.

 

[KeithGTP03]

I try to avoid them, because my boss' hot daughter is 16.

 

[thomas mcnulty]

So the 3.4 is to big for gen three but to small for this application?

 

[Fivefingerdeathpunch]

What?

Do you know what the word "flow" is?

Because you dont have it.

3.4 with only a ubend delete is jsut asking for a popped piston.

and to answer your other thing. 3.4 is not to big for anything.

Stock size is 3.8 for both Gen 3 and Gen V blowers.

Going down is sizes for each blower is different because the gen v is a better blower than the gen 3.

So a 3.6 on a gen v is like a 3.4 on a gen 3.

 

[MoarkatsINmuhtrailer]

Here we go again....


Integra>geo>Diamante>gp>aerio>cobra>the **** I took today>z06>tits???

 

[thomas mcnulty]

Ahhh power log

 

[sLpGPGT]

Damn man, thanks for the lesson. I didn't really know anything about those mustangs until now.

anytime man

 

[afallucco]

Relevant again

I try to avoid them, because my boss' hot daughter is 16.

Two years

 

[Sudden]

QUOTE=afallucco;783543]Relevant again



Two years [/QUOTE]

Maybe, maybe not, if he likes his job.
In most states the law can't do anything after 16.

 

[blueguy]

Yeah, that 3.4" needs to be traded in for a 3.0" or a 3.1" if you have race plugs and a race tune.

 

[Iceman6669]

What size pulley can I run with racing stripes???

 

[blackflag]

What size pulley can I run with racing stripes???

.005 but no lower than .002

 

[Slowpoke]

anytime man

Thanks bro! I've been wanting to install some rear gear in my 96 mustang GT, should I go with 4.10's or 3.73's? Also, can you tell me what I'm going to need for my pi swap?

 

[TheNoob23]

thread is full of tolololol

 

[02 WS6 TA]

Thanks bro! I've been wanting to install some rear gear in my 96 mustang GT, should I go with 4.10's or 3.73's? Also, can you tell me what I'm going to need for my pi swap?

I think I just sharted from laughing.