• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

24 mm bolt on crank?

L

legend

New member
We had a write up on here bit the links broke I seen thateveryone on here sad that that bolt was hard but something in the write up made it easy!??? We are replacing crank pos sensor ... Anyone know what the secret is that has done this before??
 


good impact. or put a breaker bar on the bolt and bump the engine with the start after disabling spark and fuel.
 
That sounds scary lol where do we wedge the bar? What do you mean disable the pull how would we start it? Could you explain in dummy terms?
 
T for the vid! Got it on to pulling it now with the balancer puller the volts thread into the 3 holes??
 


You will chase around forever trying to find M6 x 1.00 x75mm's. You can also use 1/4" fine pitch thread. It's not exact...but it sure works fine when you can't find m6 in the length.
 


You must log in or register to reply here.
Back
Top