• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

2007 Grand Prix GXP Back bumper issue

rockbassray

rockbassray

New member
Hi the back bumper on my GXP GP is a bit loose under it i see a foam molding with 2 mounting brackets.. the foam has broken in those spots which makes my bumper flap when going over 60MPH. any know where i can get this replaced or fixed? i am in the schaumburg IL area.
 


Mines gone there too from when the valance melted and tore those spots out.
I bought the new valance and cut 90 degree L brackets out of the old valance end pieces. Drilled holes and used new pushpins.
There are spots on the frame to fasten it to. If you slide under the bumper and check it out you will see.
Even though it's a GXP one piece bumper it should be the same principal.

Zipties
 
i dont think it is the valance.. inside the bumper there is a foam mold.. which was connected to 2 ,90 degree brackets.. the foam at those brackets snapped off from it. i think i need a new foam mold and or setup for that..
 
rockbassray said:
i dont think it is the valance.. inside the bumper there is a foam mold.. which was connected to 2 ,90 degree brackets.. the foam at those brackets snapped off from it. i think i need a new foam mold and or setup for that..
Click to expand...

Same here the foam wasnt even in my bumper when I bought the gxp. So I just tabbed up a pice of board in between the bumper and spare tire wheel
 
You must log in or register to reply here.
Back
Top