• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

2004 GPGT P0341 error code

S

stbne

New member
Crank Pos. Sensor..Had it replaced and error code does not go away..mechanic says its some magnet on the timing chain and that replacing it is the only way to fix this...Major engine work to the tune of at least $1000..so this mechanic says...Car does run rough at idle sometimes and will stall from running but it does run good everywhere else...I had to get a waiver for inspection in the state of NC...so what is the truth here?
Also ABS..Traction control and Tire Pressure warning lights are also on..
Do I need major engine work to fix the P0341 code?
Also got a P0301 CYL1 misfire....???
DiQVHHQMHLhXOJyA18gnTFQss4ejI5QLtOY-maiIXssp09qcVz94oQejPu1AFEDn9rghl0KIXyw1XEZZqHjSsA=w1280-h586-rw
 
Last edited:


if you changed it already, id try changing the crank/ cam to icm harness. that thing tends to get worn out. some how the insulation gets beaten off the wires, then you get a low circuit.

its not to hard to remove really. crank plug is the hardest, you need to use a pick through the plastic cover behind the balancer, takes a creative looking at.
 
industrialfish said:
Nevermind. P0341 is CAMshaft error, not CRANKshaft.

Did they replace the wrong sensor?
Click to expand...
oops my bad..my vision sucks with cataracts..anyways sounds like no one is saying anything about going into the engine to replace some magnet thingy....zI will try your suggestions..Thanks
 
Scottydoggs said:
if you changed it already, id try changing the crank/ cam to icm harness. that thing tends to get worn out. some how the insulation gets beaten off the wires, then you get a low circuit.

its not to hard to remove really. crank plug is the hardest, you need to use a pick through the plastic cover behind the balancer, takes a creative looking at.
Click to expand...
did you mean ECM harness?
 


no. just like i stated, cam/crank, to icm. its the short harness the cam and crank sensor plug into, it plugs into a square plug near the front v/c and the icm iirc.

the damage to mine.

001_zpsi1taot6d.jpg
 
Just rechecked..P0341 is Crank Pos.Sensor A Bank 1 CKT Range/Performance..Thats what is listed in the code book ......
 
that bad harness gave me 3 codes, and made my fuel pump quit. worth a shot to take it out and look it over.


A code P0341 may mean that one or more of the following has happened: Cam sensor wiring routed too close to spark plug wiring (causing interference) Poor wiring connection at cam sensor Poor wiring connection at PCM Bad cam sensor Damaged reluctor wheel


Read more at: https://www.obd-codes.com/p0341
Copyright OBD-Codes.com
 
Thankyou..appreciate your insights nd suggestions..We will be looking closely at that harness..my only other error code is P0301 Cyl 1 Misfire detected
 


Just checked my paperwork and the mechanic changed the Cam Sensor...so why the confusion in term..IDK.I have my own OBD2 reader ..and the DTCs are 8n the uswrs manual..perhaps thats where the error is???
 
You must log in or register to reply here.
Back
Top