2001 Grand prix gtp changing hub on front pass

[big daddy]

just got a 2001 grand prix gtp and pass side wheel bearing is bad i want to change myself cause its $375 to take it to repair shop. i watched a video on replacing the whole hub assembly wondering how difficult it will b. i have replaced my own brake pads and struts without a problem so wondering how hard this will b. need suggestions to help thru this if needed ...thanks Big Daddy

 

[Explicit_Spade]

It's basically one step past doing brake rotors, so you should be fine. Did you have any questions about anything you saw in the video or did you understand it all?

 

[BillBoost37]

Like Explicit says.

It's pull the caliper and bracket, hanging the caliper on the strut spring with zip tie or wire etc. Remove axle nut, pop axle back in with a hammer, remove 3 bolts and it's electrical connector. Overall there's a few taps with a hammer etc but it's not a hard job.

 

[big daddy]

i have a couple parts stores near me NAPA AND O'RIELLY orielly has Masterpro hub assembly #513179 for $90 is that part ok to use

 

[dsmuts]

most will say only use timken or one other brand I can't think of. I use cheap ones with good luck.

 

[Fivefingerdeathpunch]

I'd go with a SKF bearing from napa. Better quailty.

But that 90 dollar bearing could last longer than the other, its always a chance with parts. Thats where warranty comes into play.

 

[Explicit_Spade]

Because they know all they sold ya was a guaranteed piece of ****. That's all it is, isn't it? Hey, if you want me to take a dump in a box and mark it guaranteed, I will. I got spare time. But for now, for your customer's sake, for your daughter's sake, ya might wanna think about buying a quality product from me.