JustanAlias
New member
...will I have an issue with this? And if so, is there a fix?
Thanks for reading...
Thanks for reading...
1.9 Terra Roller Rockers and Pushrod angle...
- Thread starter JustanAlias
- Start date
BillBoost37
New member
Not sure what the issue is. Didn't yella's come with pushrods that were the correct length?
darkhorizon
New member
angle as in they are really close to the heads...
The YT rockers are probably going to be a bit better than modded stock... but I would check them on a L32 motor.
The YT rockers are probably going to be a bit better than modded stock... but I would check them on a L32 motor.
Hi Guys,
The pushrod is quite close, obviuosly due to the higher ratio. Make sure you check clearance especially with the GM castings. Weve seen many castings have cast flashing that needs to be filed back in some cases. Also Im assuming they are unmodified factory heads. Just check if they have been milled or not also /.
The pushrod is quite close, obviuosly due to the higher ratio. Make sure you check clearance especially with the GM castings. Weve seen many castings have cast flashing that needs to be filed back in some cases. Also Im assuming they are unmodified factory heads. Just check if they have been milled or not also /.