• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by PWNED

  1. PWNED

    Ran a 12.3 @110 (Do i go smaller pulley?)

    Ran my best of 12.3 @ 110 last night with hoosiers and I love them! I feel the car is limited as I will get some KR with 93 and a bottle of boostane 116. When I go to the track I will add another bottle and get no KR at all. Rather do this than lower timing. With that if I reset the trims I will...
  2. PWNED

    Dual Vent hose for pcv?

    I am running the FSIC and had to run a vent tube from the oil fill tube to after maf to allow the motor to not suck the oil cap in. My question is should I also run the same on the rear valve cover? Is it really needed? Or would it not be beneficial??
  3. PWNED

    Making a 3.29 Gp GT trans a 2.93 HD

    It has been years.........and cant remember what is needed. I have a 30k trans from a 99 Grand Prix Gt. I want to make it a 2.93 HD trans for my 02 regal Gs. I have the 500hp input shaft and gxp chains to bandaid it for a bit. Do I just need to swap my regal diff, output and cover to it? Or...
  4. PWNED

    ZZP Modded Rockers

    ZZP Modded 1.9 Rockers. They have right around 30k on them which netted me a 12.8 @ 108 with mods in sig. I can also include the 90# springs and modded retainers if someone is interested which I plan to remove later today and will get pictures but wanted to get the ad up. $300 for everything...
  5. PWNED

    Smokes at idle!!!!

    I have maybe 400 miles on my recent build. The motor is from a 98 with 150k. Build is XP cam, hinson ported heads, valve seals from intense. I believe they were the one to allow for high lift but hinson installed them. Now this oil smoke will explain why I get KR every now and then. Whats...
  6. PWNED

    1-2 shift shudder

    Alright! I have my XP, ported heads, double roller, 2.8 IC, ported lower build in. The car pulls harder than the stock heads and 1.9 rockers build it had before I snapped the input shaft. https://youtu.be/gsnhfXFXXRo My issue is that I drove the car normal the day after first start with the...
  7. PWNED

    Best spot for the IC pump?

    Initially when I installed my IC pump I put it in the fender area as seen per other threads. I was then told I cannot do this as the air will not be purged and the pump won't work well like this. Now being in New England I fear the pumps placement down by the frame with these up coming wet...
  8. PWNED

    ----K060680HD IC belt---

    Low miles. Ran it on my 3.0 IC setup. K060680HD Belt $25 shipped
  9. PWNED

    Why does my car like rich? Lean it KR's

    I have been working and working on this tune and thought I had it as it pulled pretty decent for what it was esp. when 3rd gear came around. This was when I was hitting an 11.0 afr. But as you see it would KR bad! Autolite 103's gapped at .050 didn't even help so I put back in my 104's @ .050...
  10. PWNED

    NGX/AFX Wideband off .2-.3 on the laptop

    Is there anyway to fix my wideband being off .2-.3 on my laptop? It is right off the battery for a good solid power/ground connection controlled by a switch.
  11. PWNED

    LTFT spikes to +16/other times perfectly fine

    I have been going in circles with this issue of my LTFT hitting +16 at times. Other times it is perfectly fine. I have sprayed brake clean and poured water on every vacuum line, gasket or rtv seal and trims will not change (usually -3-10 ltft at idle) Yes its rich but whatever. I even replaced...
  12. PWNED

    zzp 2.8 pulley

    zzp 2.8 pulley
  13. PWNED

    Fuel Trims are high and + with vented oil cap

    Recently after my phenolic IC install I have seemed to plug my pcv (the front) as my oil cap gets sucked in. After numerous removals I said screw it and stuck a hose In the side of my oil fill neck as you see so it can breath, as it is my only car right now so I need it to drive. Buying a...
  14. PWNED

    Phenolic IC ISSUES..please help. Sucking in oil cap.

    The first install I did not rtv enough to the coolant elbow side creating a vacuum leak. Second I rtved too much as the top half split and stuck to the SC. So the rtv blocked the front and rear pcv passages. Thus I got the worse whistle EVER. Third.... I just cleared out every hole and re...
  15. PWNED

    Vacuum leak? I have my doubts.

    Recently coming from a 3.4/headers/rockers/intake setup. I just installed my Phenolic Full size IC and dropped to a 3.0 pulley with no KR @ 10.5 afr and 17* timing. Now my trims are all messed up. + 7 to 13 at idle. In certain spots at cruise I will hit high teens in both trims. As on my old...
See more
Back
Top