• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by Jcinstalls

  1. Jcinstalls

    looking for wheel spacers

    ^^^ ya better lugs are a must My 00 GP has 245/35zr20 an 1" drop and 7mm spacers on the rear. If i hit a bump at high speed sometimes the back tire rubs the fender ( they aren't rolled ) But that depends on the wheel offset too I guess. Im still on the original bearings in the back and haven't...
  2. Jcinstalls

    GP in a Firestone tire commercial

  3. Jcinstalls

    GP in a Firestone tire commercial

    Here eat a snickers you whine a lot when your hungr....... All the time!
  4. Jcinstalls

    Can any1 tell me what this noise is?

    Its the the rings supported by the flat springs on the outer most part of the pulley that get engaged by the electromagnetic clutch. It didn't take much at all to bend but make sure it still engages. it
  5. Jcinstalls

    GP in a Firestone tire commercial

    Anybody else get a sense of pride when this came out?
  6. Jcinstalls

    3100 purge control valve and boost?

    Hello guys im looken for advice. Im modifying the pcv pipage to handle possitive pressure now, do i need a one-way valve on the manifold to purge control valve tube? Ive looked at what this valve does and it freaks me out because any +pressure in the EVAP is bad right? Thanks again for all the...
  7. Jcinstalls

    2000 gp turbo new pcm location?

    Were is the best place to mount the pcm? I cant find good info and i was hoping someone had advice? Thank guys
  8. Jcinstalls

    Electrical gremlins with headlights and blower motor, please help?

    2000 gp se with the base HVAC control module. I have the higher quality HIDs. My blower motor and headlights used to work perfectly. Ive replaced the blower motor resistor and the blower fuse is ok ( all fuses are ok). So whenever i move the blower switch from off, the headlights and blower will...
  9. Jcinstalls

    Compression test results?

    I had to replace the pistons in my 3100 and now each cylinder reads almost exactly 120 psi. Is that pressure good or bad?
  10. Jcinstalls

    What is proper manifold vacuum on the 3100 sfi

    Ive installed a permanent vacuum gauge and I'm a little worried and confused about what it reads. My elevation is 6,800 ft above sea level and its just a cheesy gauge that is connected to a empty port on the manifold. I have an aftermarket intake and have done things like gasket port matching, a...
  11. Jcinstalls

    Good info and a few question regarding a LIM change and the PCV system

    I thought i had oil leaking from my pan gasket ( turns out it was leaking from the oil press sensor that probally was damaged earlier 25$ autozone) so i pulled the motor out and replaced the upper intake, lower intake gasket, valve cover gaskets, thermo gasket, and oil pan gasket and eventually...
See more
Back
Top