• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by hacket

  1. hacket

    P0108 Code, Rough Idle

    Just got the MAF sensor replaced and fixed a stalling problem, but still have a pretty rough idle. It threw a P0108 code on the way home today, MAP sensor High Input. Here's some freeze frame data from my scan tool. ECT - 96 C MAP - 103 kPa Engine RPM - 883 Speed - 0 MAF - 5.31 g/s This code...
  2. hacket

    Engine choking/stalling when warmed up

    Engine died on me a couple of weeks ago on the way home. Pulled off and it started right up. Noticed that it was accelerating pretty rough/hesitating like it was wheezing. Replaced the air filter (it needed it) and the IAC valve, didn't fix anything. Finally got it to throw a P0102 code Low...
  3. hacket

    electric issue - all power loss, gauges twitching when turned to run position

    Backed out of the driveway, put it in D and the car flatlined as though the battery had been disconnected. Got out and checked the connection to the battery and it was fine. I left the key in the 'run' position and within 5 seconds, it had power again. Did it again about 30 seconds later. Then...
  4. hacket

    Projector bulbs...

    Alright so I had a headlight go out in one of my Halo Projectors this past week. I've been looking around and can't find where to buy a new one. Regular bulbs everywhere, but I'm unsure if they fit in the projector housing. Anyone know where there are some for sale or if a normal bulb would fit...
  5. hacket

    3.1 maf

    Could someone point me to where the MAF is on a 95 3.1? I've tried google and looking on here and nothing turned up. Also I've read some people unhook the MAF to see if it helps stalling problems. What is the basic effect this has on the car?
  6. hacket

    1995 GP Stalls Randomly;Otherwise fine

    Hey guys, My mom owns a 95 GP SE 3.1 and has been having an issue for quite a while. It has happened like 3 or 4 times in the last 6 months maybe. She claims the car stalls randomly, when pulling into parking lots or backing up. I got it to happen once when backing up and didn't notice...
  7. hacket

    Lug Nut Torque

    I've searched around and found a rating of 118 for the front lugs on 98-01 GPs. Is it the same for the rear lugs as well?
  8. hacket

    Control Arm Bushings & Alignment

    As I now know, my right front control arm bushing is a little worn and is starting to pull out slightly. The other isn't bad yet. My question is this, will having that bushing worn affect alignment at all? I just bought 4 brand new hydroedge tires and would not like them wearing unevenly. My...
  9. hacket

    Great Tire - Michelin HydroEdge Green X

    So last week I had 4 brand new Michelin HydroEdge Green X 225 60 R16 tires and I must say that I am not regretting it! Road noise and ride are much improved over my old Bridgestone Potenza G009's. Dry traction is stupendous and snow/ice is near perfect. I was trying to spin out the other day...
  10. hacket

    blower motor resistor

    So for the last 5 years my 1 & 2 blower positions haven't worked at all, and now last week 3 & 4 went out, so only 5 works. No other problems, and so digging around I found it's possibly my blower resistor? I went to rockauto. com and found it, but wanted to verify that it's the correct part. If...
  11. hacket

    Control Arm Bushings

    Hey guys, I posted about this a while back. The control arm bushings on my car are pulling out, and so I got an estimate done. The place quoted me at like 560ish for the whole job, without seeing the car. Does this seem a little high for this kind of repair or not? I'm planning to get...
  12. hacket

    High/Low beam simultaneously

    Has anybody ever wired their headlights so that the low beams stay on when you switch to your highs? I just bought and installed projectors and would love to do this, but all I can find is info on the fog lights staying on.
  13. hacket

    metallic scraping

    Alright I just got home from work and heard 2 strange noises coming from under my hood. The first showed up right away. Kinda sounds like that noise you hear when you change where the blower blows air through (windshild, ground, combination, etc...) But it happens every 5 seconds or so, even...
  14. hacket

    Wow

    Best new use of a Pontiac?... http://www.youreasttexas.com/Article.asp?id=1418541&spid=
  15. hacket

    2012 stuff

    What are your thoughts on all of this? I'm watching History channel, and they are talking about the end of the world happening in 2012. There is a lot of stuff that seems to fit about the prophecies....but I don't know. Thoughts?
See more
Back
Top