• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by dbextreme

  1. dbextreme

    Quick WOT Run Question

    I'm asking this to settle my nerves. First off, I know my trans is about gone if not already (after this run I heard whining and a bit of knocking in gear). Mods are in my sig. I swapped to a 3.2 pulley and went for a test run. I drove around to get the car warm before I opened it up...
  2. dbextreme

    TOP SWAP Fuel Pump Questions

    Today I was driving and my car just hiccupped then died.. No start at all afterwards. I opened the hood, hit the Schrader valve and just a little drizzle came out. I know not a good way to check fuel pressure, but I was in the middle of the road.. Towed the car home, turn key I can't hear the...
  3. dbextreme

    L67 LIM and Spare SC or SC case

    Anyone out there have a L67 LIM and or Gen III supercharger or supercharger case laying around they want to part with? I'm looking for something to practice porting on. I'm located @ 37379
  4. dbextreme

    Sub Frame Bolt and Washer/Bushing cap whatever it's called...

    Somehow the rear passenger subframe bolt came out of my buddies 97 GTP. Anyone have a spare bolt and metal "cap"/washer laying around cheap? I don't have a pick and pull anywhere near me. The two salvage yards close to me, one said it's not worth it to them to pull it off for me nor will they...
  5. dbextreme

    P0171 Code LTFT Maxed @ Idle

    Ok I have a 99 GPGT with the mods in my sig along with an Intense custom tuned PCM. I have an Aeroforce that I am scanning with. I have researched and researched, tweeked and tweeked and am about to come up with it's in my tune but wanted to ask here first. I am setting off my SES light with...
  6. dbextreme

    Top Swap leads to P1811

    Ok, I know obviously what I need and I will be ordering a TEP trans within the year. I just can't at the moment after my build or I'll be single if I don't get other honey doo's done... LOL 1999 Grand Prix GT 154K. Before the top swap build the trans worked flawlessly. Even with my foot, I...
  7. dbextreme

    Idle Air Control Valve Question...

    I put the Northstar throttle body on my car. The Idle Air Control Valve (suppose to have been tested before shipped to me from Intense) clicks with the key on. There's not pattern to it, just click click click with long and short pauses... I turn the key off, it stops. I took it out and replaced...
  8. dbextreme

    Top Swap w/codes P0463 & P1643

    Ok, got the motor installed and running. The thing fires right up and idles smooth (strange for a XP cam) LOL but it is idling at 1100 - 1200 RPM. All my vacuum is correct, I had an issue with my fuel pressure regulator vacuum I had running to it was wrong but have since fixed. Now when I shut...
  9. dbextreme

    MPS Vent Screw Question

    Ok, I installed my hub on the snout along with my pulley. It's on as far as it will go (using the zzp puller/installer) but the vent screw will not go in the end now. The MPS came with a lil black push in deal, is that was I use? Surely not, it just slides in and falls out... I'm not suppose to...
  10. dbextreme

    JP Double Roller Crank Gear Question

    I went to put my Crank Gear on the crank and it no way no how wants to slide on by hand. The stocker slid right off, assumed the new one would slide on. Assumption is the mother of all F up's, but dang.. Is there a trick? Is it a press/tap on? I searched and someone said use some fine grit paper...
  11. dbextreme

    N* Gen III Adaptor Plate

    I ordered the ZZP adaptor plate and based on the pic it did have the vacuum tube coming off of it. When I received the plate it did NOT have the tube, nor a hole to screw one into... Did I get shipped the wrong one or am I overlooking something??? Is there another spot to plug the large vacuum...
  12. dbextreme

    Knock Sensor ???

    I am preparing my L26 motor for my Grand Prix and am researching all the sensors. I noticed all are the same except for the Knock sensors. I'd like to keep the ones on the L26 instead of using the ones on my old L36 since they are a lot newer, but they are a different part number. Question is...
  13. dbextreme

    Engine Motor Mout Bracket

    I am looking for the horseshoe bracket that mounts to the front of the motor. I threw #1 rod in my motor and it busted out the block right behind the AC compressor and bent mine all up.. I don't feel like bending it back into shape.
  14. dbextreme

    Northstar & MAF Question

    Ok quick question I hope you all can help me with. I have a N* throttle body I am using but I am wondering about the MAF. What I have heard or read about regarding MAF's 1) Have to use LQ4 or similar MAF with adapter harness and tables due to outflowing the stocker 2) Why the stocker can't be...
  15. dbextreme

    TB and Pulleys

    Looking for a L67 TB and modular pulleys 2.8 - 3.3, and 3.6
See more
Back
Top