• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by Clar2478

  1. Clar2478

    Hubs are loose

    The shop I took my car to told me my hubs are loose on the front and that you can't repack the bearings on them and they are trying to tell me its $700 for two new hubs. I'm probably going to end up just buying my own parts, but do I just order new wheel bearings and have them put in, or or...
  2. Clar2478

    Turn Signal Module

    Where is it located on the 04+ Grand Prix's? it should look like a large black square, like the ones on the fuse block but none of those are for the turn signals. I'm looking to replace it for one adjusted to work with LED turn signals to fix the flash rate.
  3. Clar2478

    Wo has changed the case bearings out of a GEN V????

    Tore apart my car this morning to change my case bearings. Started following the instructions I was given that were used on the gen III until I got to where I have to grease out the old bearings by tapping the two indents on the bottom side of the SC. well... the gen V doesnt have those indents...
  4. Clar2478

    Where can I get one?

    My car never came with the little rubber pad attached to the dash that sits right below the ignition. Does anyone know where I can buy one from? Besides a junk yard.
  5. Clar2478

    What's next?

    I just got an email saying I've got a $500 check in the mail for a sponsorship for the next racing season since this one is almost over for me. The question is... What would be the best thing to put the money towards? It's my daily driver so it can't be anything too extreme and I dont want to...
  6. Clar2478

    Swapping PCM's

    I've got a 2005 PCM that I am going to tune this sunday for my 2006 GT. We're going to be using HPT to tune it, my question is about the VIN though. With the 2005 PCM being out of a different car I realize the VIN needs to be changed to match the VIN of my car. Am I going to have to pay for two...
  7. Clar2478

    3" catted zzp downpipe

    If someone has one could they please tell me what the length of it is from the BACK of the cat to the end of the back flange on the downpipe? My back flange was cut off when they replaced my resonator with 3" pipe so i'm trying to weld a new flange onto the downpipe so I can sell it.
  8. Clar2478

    Replacing bearings for SC case

    Does anyone have a how-to on this or some basic instructions?
  9. Clar2478

    Preferred Oil

    I'm just wondering what everyone else is using as far as brand/type of oil.
  10. Clar2478

    Wire tuck

    Who has done one on these cars? If no one, has anyone had any experience with wire tucking on any other cars? I'm looking into it btu I would like some information and possibly some pictures on how to go about it.
  11. Clar2478

    Removing the unecessary

    Looks like I'm going to remove my EGR, I was wondering if anyone had any tips or if they could post a quick step-by-step on how to do it. While we're on the subject, what are some of the things that can be removed with keeping the functionality of the car? I've noticed in a few posts that...
  12. Clar2478

    Supercharger Noise

    Popped the hood today just to look a few things over while it was running and immediately noticed a noise coming from the supercharger. It sounds like the rotors were grinding. Not like a TERRIBLE grinding, but it definiktely sounded like there was more friction between them than there should...
  13. Clar2478

    Best 4 piece grill set for 04+

    I'm looking at getting some different grills for my 2006 and I want to get some higher quality one that aren't ridiculously over priced. Any suggestions?
  14. Clar2478

    What would you think?

    I've got someone willing to powdercoat my current wheels in a wet black for a price that's tough to refuse. So I thought I'd come here and see what some of you think about how it'd look on my car. heres a couple pictures of what the wet black is going to look like: And here's a picture of my...
  15. Clar2478

    Cleaning up the engine bay

    Does anyone have any good info on how to make the engine bay on these cars alot cleaner looking? I'm not necessarily looking for a full wire-tuck job, but something along those lines.
See more
Back
Top