• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by bfox507

  1. B

    shifts 2nd to 4th with no 3rd

    hey guys I've been having trouble with my trans of late. my trans will not shift into 3rd gear it goes straight from 2nd until about 45/50 mph then shifts into OD. Ive read some some later posts that this means that my tranny is shot now which I'm really hoping isnt true. the mods i have in...
  2. B

    Full trans rebuild but feels like its in neutral

    I recently just got done my complete rebuild of not only my engine but also my trans. I have a 2004 impala ls and originally did a top swap on it along with an xp cam but had a problem with that engine and shattered a piston. I then bought a lower milage l32 engine and completely rebuilt from...
  3. B

    trying to figure out bearing size from stampings

    hey guy I'm in the process of rebuilding a l32 completely. I'm just stuck on lower end because i can tell if the rod bearings and the mains are standard size. I've searched every stamp mark I've found on them and can't seem to come up with anything reliable. when taking apart this block I've...
  4. B

    Recommendations for pulley

    Hey guys I currently am in the process of rebuilding a l32. I'm using an xp cam, zzp CAI, northstar TB, zzp headers wit hi flo cat DP, and res delete, colder plugs upgraded fuel pump and bosch green giant injectors. What would be a good place for me to start with the pulley size I currently have...
  5. B

    short block

    looking to buy a new short block thats in good condition
  6. B

    smallest pulley i can run?

    hey guys i recently was having problems with my boost number because i was running a top swapped l36 with xp cam 3 inch hi flo catted DP and CAI... basically everything except headers andf i was only getting 4 psi of boost with a 3.4 pulley. i checked everything and my bbv is working right and...
  7. B

    3.4 pulley and only 5 psi boost at full throttle?

    hey guys I'm running into a problem with my boost number i did a gen 3 top swap with xp cam, 3 inch hi flow cat down pipe and new dual exhaust off an 04 impala ss on my 04 impala ls. I changed the pulley to a 3.4 to get at least 8 to 10 psi and I'm not even see in close to that. I'm only...
  8. B

    3.4 pulley top swap and only seeing small boost

    i just recently top swapped my 04 impala ls with a gen 3 blower. i am using stock l67 injectors and i also installed a xp cam with all the necassary mods such as 140# valve springs, DR chain, modded retainers, etc but i also am running a 3.4 MPS. I have all the gauges i need connected and...
See more
Back
Top