• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Afternoon All, New Grand Prix owner here

JimW

New member
I have just become the proud 3rd owner of a 98 Slivermist GTP coupe. Fully equipped with Black leather (but no sunroof)
I purchased it from my best friend who in turn had purchased it back in December '11.
At the time of purchase it had 142,142 miles on the odo, and body-wise it is in near mint condition.

It has just recently (before purchased in Dec) had the S/C snout changed, LIM, full tune-up, trans. service, S/C oil change, front wheel bearings and outer tie rods. The rest of the car seems solid and she runs great.

I have already taken the car to E-town and in full-street trim with just a cooldown with the hood popped has run 3-14.8's @ 93.36 MPH on a best 2.27 60' time. (which from what I see is dead on for a stock GTP)

All I've done so far is tint the windows, but my goal for this car is to get her into the low 14's with basic bolt ons. A 14.2 would give me the giggles, but a 14.0 would be perfect.

I've already read the sticky on "how to safely mod your 3800" and my first mod will be the install of the U-bend delete pipe hollow then a pulley. Then later, a good tune and I think I should be where I want to be.


I live in Central NJ, and will be frequenting E-town before summer either with my GTP, or my other car, (00 Audi A6 2.7T 6spd, Stage 3+) which I'm trying to get into the 12's with some better launching and a new clutch.

If anyone would like to hang sometime, shoot me a pm.

Just wanted to stop in and say "Hello".

Jim
 


Welcome.

You might want to read that thread over. Just from my understanding you think you can run a smaller pulley on just a ubend delete. You will need atleast a plog/downpipe or headers (best route) to do such. Then plugs and tune.

But anyways, enjoy your stay.
 
Welcome.

You might want to read that thread over. Just from my understanding you think you can run a smaller pulley on just a ubend delete. You will need atleast a plog/downpipe or headers (best route) to do such. Then plugs and tune.

But anyways, enjoy your stay.


Thanks,
It wouldn't be the first time I've mis-read something. Will re-read in greater detail.
 
Back
Top