Cheap Mods

[Bio248]

This is the way i did mine

you left the restrictive part of the intake there. remove the corrugated tubing and replace with something smooth walled.

 

[dpzelenak]

you left the restrictive part of the intake there. remove the corrugated tubing and replace with something smooth walled.

I was going to do that but i couldnt find anything that had holes for the IAT and the vacuum hose and i didnt have time to drill and tap the holes myself so i said forget it...until i could take the time to make my know and do it the right way

 

[2000GrandPrixGT2000]

Just buy a 4" 45° elbow and a 4" coupler to replace the corrugated tubing
I used the excess metal hanging off the worm clamps on the coupler to hold my IAT sensor

See that little bit of excess in that pic above the YDS logo?
I just tucked the wire for my IAT sensor in there and it holds the sensor right there next to the tube without moving

 

[dpzelenak]

so you put your IAT outside of the tube( or hose) and where did you get the elbow's and pipes?

 

[Bio248]

the IAT doesnt need to be in the tube. it needs to be somewhere near the cone so it's reading a similar temperature.

 

[coreygnar]

for a while i had my iat wedged in my filter, every so often it would fall out, but i just put it back

 

[2000GrandPrixGT2000]

so you put your IAT outside of the tube( or hose) and where did you get the elbow's and pipes?

I got it at advance auto parts, here is a link
4" elbow: Advance Auto Parts: 4" Aluminum 45-Degree Elbow by Spectre - Part 9749

Coupler to attach to TB: Advance Auto Parts: Coupler/Reducer 4" to 4" or 3-7/8" by Spectre - Part 9771

 

[dpzelenak]

I got it at advance auto parts, here is a link
4" elbow: Advance Auto Parts: 4" Aluminum 45-Degree Elbow by Spectre - Part 9749

Coupler to attach to TB: Advance Auto Parts: Coupler/Reducer 4" to 4" or 3-7/8" by Spectre - Part 9771

Ok thanks i never thought of doing it that way and plus i was 15 at the time..so now i can do it the right way....Thanks