• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

how high can an L67 rev



unless you have a very large cam where it makes power up there, then there is no point in ever going over 6500 or so. never push the car past where it makes power because youre not helping anything.

with the right setup, id assume you could push the motor a little over 7000 rpm.
 
my shift points where set at 6800. The only way your gonna get that high is with a upgraded top end then a cam that can make power
 


bluegtp91 said:
^^Mod list?

I'll be shifting at 6500...that's enough.
Click to expand...

What did i not have done LOL
2.6" Daily pulley
ZZP Stage 2 IC
Machined intake
CC #105 springs
CC LS1 Retainers
CC Pushrods
CC Lifters
Diamond pistons .020 over bore
PRJ Double Roller Timing Chain
SI vavles
Intense Stage III cam/heads
PRJ fuel rails
Race Tranny w/3.29's
I had one of the pcm's that zooomer had in his car
 
Toofastgs said:
What did i not have done LOL
2.6" Daily pulley
ZZP Stage 2 IC
Machined intake
CC #105 springs
CC LS1 Retainers
CC Pushrods
CC Lifters
Diamond pistons .020 over bore
PRJ Double Roller Timing Chain
SI vavles
Intense Stage III cam/heads
PRJ fuel rails
Race Tranny w/3.29's
I had one of the pcm's that zooomer had in his car
Click to expand...

Jesus. What was your 1/4 mile?
 
You must log in or register to reply here.
Back
Top