• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Header Install ran into some problems

jayroca

jayroca

Banned
Ok guys ran into some problems with the headers... first off they are speed daddys I wanted to install everything to the front manifold to the rear was ok.. until.. the flex downpipe and o2 extension bolts were all rusted any ideas on takin em off? Could I pull the whole assembly out?

Sent from my SAMSUNG-SGH-I747 using Tapatalk
 


PB Blaster and a torch are your best friend. Heat the bolt/nut for a minute or so, then soak with PB, repeat unti desired results are achieved.

And yes, you should be able to pull the whole rear section out, though it is much easier pulling it out 1 piece at a time.
 
machinegunsquid said:
PB Blaster and a torch are your best friend. Heat the bolt/nut for a minute or so, then soak with PB, repeat unti desired results are achieved.

And yes, you should be able to pull the whole rear section out, though it is much easier pulling it out 1 piece at a time.
Click to expand...

Thanks I'll try that

Iceman6669 said:
I used a hack saw and cut mine in half.
Click to expand...

Where did you used the hack saw at?
Down near the flex? Or a little up close the o2 extension


Sent from my SAMSUNG-SGH-I747 using Tapatalk
 
da4a3yta.jpg
kind of an idea
 


You must log in or register to reply here.
Back
Top