• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

YT 1.95's and L76 springs

Slow06GTO

Slow06GTO

New member
I recently picked up a set of YT 1.95's and was planning to use ls6 springs/retainers until i read they are so hard on the timing chain dampener. I know L76 spring are cheap and will put less stress on the dampener but will they still keep valve float in check with the new rockers? I plan on keeping shift points where they are now at 6k. Thanks
 


Yeah I wasn't planning on using the stock springs. I have ls6 and l76 springs I can use. JUst trying to confirm the L76 will work with the setup with shifts at 6k.
 
Answer in a nutshell:

Yes it will work, plenty of guys have run it successfully with no issues. Especially since you are only wrapping it out to 6K.

Regardless there cheap as **** so even if you buy a full set it wouldn't be that difficult to turn around and sell them if you opt not to use them.
 
You must log in or register to reply here.
Back
Top