Which push rods should i use with VS camshaft and LS7 lifter

[ice2484]

Trying to figure out which push rods to use.
Got ZZP VS cam shaft and LS7 lifters. The stock push rods are to long.
6.95 or 7.00 push rods?

The push rod tool I get 2.5 turns.
Measuring the push rod tool is 6.93"
Turning the bolt on rocker arm I get 1.5 turns

 

[Iceman6669]

6.95 has been the size I have seen most guys end up using on a CompCams cam and LS7 lifters.

 

[fst]

looking over my old emails I believe I ran stock pushrods with 105# springs and new retainers and seals on the valvetrain

 

[fst]

wtf is the edit button to edit my original post? anyways I ran modified retainers from zzp.

 

[ice2484]

The 6.95 are the ones i was thinking about using. Just trying to make sure i use the right ones.

 

[BillBoost37]

Likely the lifter has enough uh..movement that it'll work.