Spark Plug Wire Retainer

[smitz327]

I have a 2002 GTP and on the supercharger, I have one spark plug wire retainer missing but I cannot seem to find the part number for it even on GM's parts. It mounts right on the supercharger, any help would be appreciated

 

[Fivefingerdeathpunch]

I bet it would be hard to find one, unless it's from the junkyard.

You could just route the wires under the supercharger snout and not need them.

 

[smitz327]

I will give the dealership and the junkyard a try and if no luck, I will run them under.

 

[Scottydoggs]

you could steal the wire clip thats on the back of the engine, if its still there.

 

[Speedy1973]

if it's the things i'm thinking about. i have a couple of them

 

[BillBoost37]

Are you talking about the one that held the wires front and back it was one piece that was held on by two bolts of the snout?

 

[smitz327]

Here is a photo, its near the back with the clip hanging

 

[BillBoost37]

The parts stores have them in the help section.

I thought you were talking about the good one

 

[smitz327]

Are you speaking about on this website under parts?

 

[Scottydoggs]

Are you speaking about on this website under parts?

no, he means the "help" section at any parts store local to you. it where they keep/ sell all the little odds and ends.

 

[smitz327]

Ok, I will stop the store today. I will post the part number on here too.

 

[BillBoost37]

See...I thought maybe you were talking about the one and only wire holder than any Gen 3 M90 owner should want and love.

 

[smitz327]

Didn't find anything at the parts store. Where did you get yours at?

 

[Scottydoggs]

i asked bill in chat where it came form, he said it came on some Bonneville superchargers. so dealer or junk yard for that cool part.

 

[Z34Phoenix]

to use that wire holder you need the holder and two different SC bolts as they have extra nuts that hold it on. i grabbed one off a boni a while back and have yet to use it. I like the look of the blower with the wires tucked under the snout.

 

[BillBoost37]

Sounds like Z34 might have one for sale!

 

[Z34Phoenix]

Currently it resides in my rare wbody parts pile. I once had a cutty convert strut tower brace. Actually two of them but sold them cause they did t fit well with the DOHC. I wish I had one again for the 3800.