pulley drop 05

[wlmrt6]

I have an 05 gtp and im thinking about dropping to a 3.6 pulley. i will be getting an intake a zzp 3" downpipe wiht high flow cat, 180* tstat, ngk 1 degree colder plugs, and an intense racing tune. what pulley should i get to where i dont have to rent a tool to put it on or take it off??? also would like to know what brand of pulley is better? and will i need a new belt?

 

[OH4CompG]

First thing, a little food for thought. I have an 04 gtp with headers, open cone intake, autolite 104's (two heat ranges colder), a tune, a 180 stat, and a 3.6 pulley. I still see up to 3-4 degrees of kr when I race at the track at times. I don't think you should pulley down with any less of a mod list than I have. I'm going to rocker it soon with some 1.95's and see if it'll take a 3.4. If not I'm intercooling. As far as pulley brand, I run a pulley boys pulley. Intense or zzp pulleys are good too.

 

[Bio248]

ZZP and intense are best to start with because they are easiest to find used.

 

[TheOtherNick]

FYI intense and zzp pulleys are interchange able.

 

[dirtmaster88]

First thing, a little food for thought. I have an 04 gtp with headers, open cone intake, autolite 104's (two heat ranges colder), a tune, a 180 stat, and a 3.6 pulley. I still see up to 3-4 degrees of kr when I race at the track at times. I don't think you should pulley down with any less of a mod list than I have. I'm going to rocker it soon with some 1.95's and see if it'll take a 3.4. If not I'm intercooling. As far as pulley brand, I run a pulley boys pulley. Intense or zzp pulleys are good too.

X2
I also have those exact mods and also see that much knock.