• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Ok...searched high and low with no results, so here it is:

N

NCBikerBoy

New member
Define irony: I have a SEL on, but can't figure out what the error code is because apparently my OBD-II connector has no power! Anyone? Anyone? Beuller? Beuller?:th_scratchhead:
 


I have a similar issue going on...but I checked my fuses and even replaced it just to be sure and still nada....scanner says "communication line terminated due to over current protection"...car runs fine...but the light bothers me....happened around the same time that my airbag light came on lol
Hope yours is a simple fix my friend :-)
Sent from my SGH-I777 using Tapatalk 2
 
Last edited:
Lighter works fine, power outlet works fine; just no juice to the OBD-II connector. I'll recheck my fuses, but if the lighter's working, I don't see how it could be blown. Thanks for the input, guys! Anyone else?
 
check the wires on the back of the obd port, (wires break off sometimes) also make sure the inside of the plug is clean, no dirt or lint inside it or anything that could keep it from connecting.
 


Mine did this once. Turned out my PCM was messed up. It worked fine with everything else except reading and writing to it. Had to replace it.
 
You must log in or register to reply here.
Back
Top