• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

O2s for SC cars

Sabrewings

Sabrewings

New member
Now that I've got the M90, I know my O2s should be higher than they were N/A. They're currently in the 920 range. Anyone think I should move them or just spark tune with it right there?
 


are you knocking? lean it out until you knock, then add a little fuel. from there then you start adding timing.

i started out with 10* of timing to etch out my fueling and then added more timing once i found where my fueling was supposed to be.
 
With the blower all warmed up I get as much as 6* at WOT. That higher CR is going to fight me for every degree of timing I want. With the engine warmed, but the blower still cool to the touch, I can floor it with no knock.
 
Anyone know what cells to adjust for WOT timing, so I can do like Bio said and run like 10* until I get my fueling ironed out?
 


The far right column in your spark table starting at around 4400 RPM and moving all the way down.
 
Ummm... I'm not too sure about DHP. I assume the tables are set up very similar.

WOT.jpg


You may want to lower the cells around the 10* ones just to make a smoother transition.
 
Last edited:
You must log in or register to reply here.
Back
Top