• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Needle bearings



Gen 5 bearimg are open both sides. They go into a bore that is totally closed. Even if there was a cross drill the bearimg isn't closed.

You need an internal bearing puller and a slide hammer.
 


well that sucks. the gen3 is super easy compared to that, then.

either way with the right puller it can't be terrible. oh well, i tried. good info.
 
Are you sure is my question powdercoating ovens get over 400° if im not mistaken. Are we sure that it wont mess up the needle bearings. If this is so i will not mess with them
 


The grease and seal are not rated to 400.

I replace a set in a powder Coated blower, they needed done. The case was bead blasted but the grease wasn't right.
 
There probable fine tell you bake them to 350-390. If you don't bake them, clean them out and regrease them.
 


You must log in or register to reply here.
Back
Top