My blower porting project..

[minichopper6hp]

machined open inlets have to blend it still but i thought i would share...

 

[Bio248]

Re: Who likes....

nice...now put some aluminum epoxy in all the holes minus the BBV.

 

[minichopper6hp]

Re: Who likes....

plan on it

 

[minichopper6hp]

cutting out the v right now.

 

[TDCRacing]

Found it. LOL

 

[minichopper6hp]

well, what do you think?

 

[TDCRacing]

I like it. Those pics look a lot better than those other ones you sent me too. LOL


What I did to my last one was sand the inside down with some 1000 grit. It was like glass when I was done. I think it turned out good.

 

[minichopper6hp]

im workin on it.

 

[minichopper6hp]

what was wrong with the other ones, they were progress pics. at that point i had not smoothed the inlet. right now i have the inlet 90% smoothed out now, just machined the inlet to 76 mm as in the photos and as of now im putting a v 45 degree cut on the outlet.

Ill post pics. I might be offering these for sale also, you will get for $150, outlet work, inlet work, snout machined for smaller pulley and powdercoated color of choice, red,black,yellow,white,blue. More colors can be ordered upon request, i just stock those normally. can also put in new bearings and seals for extra.

 

[Bio248]

that's a good deal for that much work on it. do you plan on taking out the h-bar too?

 

[Scimmia]

as of now im putting a v 45 degree cut on the outlet.

que??

 

[minichopper6hp]

^^^ added pics

 

[minichopper6hp]

put a 45 degree cut on the V outlet, just like zzp does. Helps with exiting air to reduce temps.

 

[Scimmia]

put a 45 degree cut on the V outlet, just like zzp does. Helps with exiting air to reduce temps.

I gotcha now, basically beveling the edge. I thought you were talking about a new cut or something.

 

[minichopper6hp]

bump

 

[minichopper6hp]

so, does anyone sound interested?