interior mods! heres a few of mine what about yours?

[putskijr]

post up your interior mods or anything along those lines. Some people are lookin for new ideas and thought this might be a good start to look! :th_thumbsup-wink:
grandprix pictures by putskijr - Photobucket

 

[matt5112]

Honestly, interior of these cars are ****, and always will be.

"can't polish a turd"

The accents are decent, but borderline overboard.

 

[noreasonwhyy]

i'd take ecstasy and rolll around with you. otherwise, no.

 

[josemolina2008]

that light would must look sick when you play some techno music

 

[Mad Monkey]

holy air fresheners batman.. lol

 

[shawngtp]

wow I am ready for the club now!!!

 

[nikkigpgt00]

I LOVE the silver accenting! What did you use to do all that? I'd love to do that. Was it hard to remove the pieces?

 

[putskijr]

I LOVE the silver accenting! What did you use to do all that? I'd love to do that. Was it hard to remove the pieces?

pm sent! the only two that sucked were the two side vents

 

[putskijr]

holy air fresheners batman.. lol

those gathered from the time i bought the car a year ago lol

 

[1LoudGrandPrix]

those gathered from the time i bought the car a year ago lol

just put 2 under your seat works well

 

[putskijr]

bumppp

 

[christopher8911]

I just added a few cf accents. Will see if I can get a pic up in a few.

 

[Bio248]

i made my interior mods functional:

painting the interior is for ricers. also, i hate your for bumping this thread, puts.

 

[Ibwrong]

Holy switches batman, what size hole saw did you use for the gauge holes in the cubby?

 

[Bio248]

...the right size? i dont remember.

switches: red lights under the dash (previous owner, gay), alarm to valet mode switch, and my perf. shift switch.

gauges in cubby: fuel pressure and wideband.

gauges in a pillar: volts, oil pressure, boost/vac.

 

[matt5112]

...the right size? i dont remember.

I'm with you.

Just trace it out then start dremel'ing away. Stop when it barely fits in.

 

[Thunderturd]

Gauges are 2" 1\16th. Make the hole 2"

 

[christopher8911]

Gauges are 2" 1\16th. Make the hole 2"

Yea, use a 2" hole saw bit or a 2" paddle bit on you drill

 

[MeanGTP98]

I used a 2" hole saw and just sanded it a bit so the gauge slid in nice and snug.

 

[sonyz92]

where did you get the CF dash gauge inlay? have been lookin for one and cant seem to find one